Miku, I take note on that.
Carlos MkIII is good too compared to SR200 it has a punchy bass while SR200 is like you're having a Subwoofer.
And yes the speaker has low power handling but I'm not blasting it out, yeah you know play music just to relax.
That´s cool!
I am glad that you are satisfied with that amplifier,my plan is to make SR200 too-i have allready done some prepairing. That amplifier is something that is "must have" !
Thank you very much APEX for helpful Technical support.
Set 15mV on 0R47/5W not 50mV it's my mistake.
Ive Etched and started to built up the New pcb from Alex_MM SR200 Ver3.1
I have some questions,
1.) I see Mr Alex included 2x100nf decoupling into the 'signal' ground from the 15V rails,
I don't see this on the Original Circuit Diagram, just wanted to check if this is best to add ot leave out ?
2.) I need the voltage rating of two capacitors,
C9 ? I'm guessing it should be a high voltage ?
C7 ? I'm guessing that a low voltage would do,
But Id prefer to know what Voltage rating is correct,
In attached picture is my litttle amp progressing and the SR200 v3.1.
Thanks so much
I have some questions,
1.) I see Mr Alex included 2x100nf decoupling into the 'signal' ground from the 15V rails,
I don't see this on the Original Circuit Diagram, just wanted to check if this is best to add ot leave out ?
2.) I need the voltage rating of two capacitors,
C9 ? I'm guessing it should be a high voltage ?
C7 ? I'm guessing that a low voltage would do,
But Id prefer to know what Voltage rating is correct,
In attached picture is my litttle amp progressing and the SR200 v3.1.
Thanks so much
Attachments
Hey, I'm here man.
busy again
Junie, Your ONPOW button and chassi are available in Popular Electronics??
Regards,