Tinitus - I have ordered slightly too large 'lytic caps for C6 and C7 it's an awkward fit. Apologies for this, I may get correct ones in the new year.
guess I could have made the same mistake myself
hmm, cannot check yet
I suppose there is a delay on the board orders with parts kit
Excellent solder job except for R6 perhaps?
Well spotted Per. I re-flowed it after looking at the pics. I find a good camera close up is excellent for inspection.
Tinitus - I have ordered slightly too large 'lytic caps for C6 and C7 it's an awkward fit. Apologies for this, I may get correct ones in the new year. I would advise soldering C7 inside pin before R7 maybe.
Per's BOM specs says 8mm
and these are indeed 10mm
(specs on ordered cap says 8-10mm)
I hope it will still be possible
can I please ask to accurately measure distance between solder pads ends
would it be possible to 'bend it over', and solder one side first ?
The cap shall be 8 mm diameter to fit. It's approx. 11 mm across the pads.
Hi Per,
Is it too late for this GB ?
Thanks
Serge
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Group Buys
- Sjöström Diamond Buffer group buy