yes. that what i ment
yes i know but not everybody knows
just so you get a little peace
OK, no problem. I'll add to the top screen
Hi all!
What cap do you think it's best for the purpose?
LLS1J103MELC | LS Series 10000 uF 63 V ±20 % Snap-In Aluminum Electrolytic Capacitor | NICHICON - Future Electronics
Digi-Key - 565-2698-ND (Manufacturer - ESMH630VSN103MR50T)
Digi-Key - 338-1569-ND (Manufacturer - SLPX103M063E9P3)
Or any other suggestions?
Does the PSU board accept 35mm caps or only 30? Because then there are more options.
Thanks in advance
What cap do you think it's best for the purpose?
LLS1J103MELC | LS Series 10000 uF 63 V ±20 % Snap-In Aluminum Electrolytic Capacitor | NICHICON - Future Electronics
Digi-Key - 565-2698-ND (Manufacturer - ESMH630VSN103MR50T)
Digi-Key - 338-1569-ND (Manufacturer - SLPX103M063E9P3)
Or any other suggestions?
Does the PSU board accept 35mm caps or only 30? Because then there are more options.
Thanks in advance
I believe UKToeCutter made the PS board so it can accept 35mm caps (someone correct me if I am wrong). If you are looking at a 63V capacitor, I'd go with this personally:
Panasonic TS-HA 63V/10,000uF
Panasonic TS-HA 63V/10,000uF
Folks:
I was considering using this cap in two of UKToecutter's power supply boards for the F5T I hope to build:
381LX153M063A062 Cornell Dubilier Aluminum Electrolytic Capacitors - Snap In
Being a newbiw, I gotta ask: are there reasons, aside from cost, to avoid this capacitor? I've happily used Panasonic TS-HA caps in the past, but they don't offer 15ku/63v options, and I thought 240ku of capacitance per channel was a good goal.
All advice appreciated.
Regards,
Scott
I was considering using this cap in two of UKToecutter's power supply boards for the F5T I hope to build:
381LX153M063A062 Cornell Dubilier Aluminum Electrolytic Capacitors - Snap In
Being a newbiw, I gotta ask: are there reasons, aside from cost, to avoid this capacitor? I've happily used Panasonic TS-HA caps in the past, but they don't offer 15ku/63v options, and I thought 240ku of capacitance per channel was a good goal.
All advice appreciated.
Regards,
Scott
I believe UKToeCutter made the PS board so it can accept 35mm caps (someone correct me if I am wrong). If you are looking at a 63V capacitor, I'd go with this personally:
Panasonic TS-HA 63V/10,000uF
Hi Horio,
Thanks for the feedback.
What about this Nichicon?:
LGU1J103MELC Nichicon Aluminum Electrolytic Capacitors - Snap In
Also rated at 105c and seems to have better ripple current handling. However it costs $3 more. Do you think it's worth it?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- F5 Turbo Circuit Boards