Hi
this is an old thread but I hope someone is still listening in:
I have bought the DIYINHK ES9023 quite a while ago and it sat unused in a box since then. I have a amplifier project right now which I would like to feed from this DAC board, however I would like add a crystal to the board.
Anyone can share working outfits of this board and corresponding BOM for the neccesary parts? I am not an expert with crystals and their implementation.
thanks!
this is an old thread but I hope someone is still listening in:
I have bought the DIYINHK ES9023 quite a while ago and it sat unused in a box since then. I have a amplifier project right now which I would like to feed from this DAC board, however I would like add a crystal to the board.
Anyone can share working outfits of this board and corresponding BOM for the neccesary parts? I am not an expert with crystals and their implementation.
thanks!
Have a look at this thread...
http://www.diyaudio.com/forums/digital-line-level/240038-diyinhk-es9023-20-ebay-2.html
Hope it helps.
http://www.diyaudio.com/forums/digital-line-level/240038-diyinhk-es9023-20-ebay-2.html
Hope it helps.
Have a look at this thread...
http://www.diyaudio.com/forums/digital-line-level/240038-diyinhk-es9023-20-ebay-2.html
Hope it helps.
Thanks Marce, this IS the thread. I read through the post and could not find a good answer to my question (what parts to I need to add an oscillator to the board).
yup, crysteks are available at mouser.com, and DIYINHK have NKDs for sale on their website (NDK NZ2520SD 3.3V 80Mhz 49.152Mhz 45.1584Mhz 24.576Mhz 22.5792Mhz 12Mhz Ultra low phase noise oscillator - DIYINHK).
Do you know which to take? What additional parts do I need (like SMD caps, resistors)?
Do you know which to take? What additional parts do I need (like SMD caps, resistors)?
- Status
- Not open for further replies.