Yes,but im building the standard version so i dont go broke
an mje15003 is 10 and an 2sc5200 is 4 money,but i will try to find something even cheaper like 1-2 money
4 romanian money units=1 euro,plus the fact that in shops they are more expensive and i want to build a 4-5 channel amp
an mje15003 is 10 and an 2sc5200 is 4 money,but i will try to find something even cheaper like 1-2 money
4 romanian money units=1 euro,plus the fact that in shops they are more expensive and i want to build a 4-5 channel amp
Last edited:
Have you built a mains bulb tester? Sometimes referred to as "dim bulb tester".
Have you read up on the tester and why it helps stop you blowing equipment up?
yes i always use it,but the problem is i dont know hou to make a propre star ground,thats why my projects have been unsucessfull
AX11 with TO3 outputs
Wow can you post the etch file for this one please?
Wow can you post the etch file for this one please?
it was done by a friend of my,"Dude" from another forum.
here you go:
Attachments
Looking on top view, B of MJ15004 was connected to .22R/5W on the output??? Or maybe one of them mounted under PCB?? Just confused maybe i'm wrong....
Regards,
Yes, there is mistake, MJ15004 must be rotate 180deg.
hello apex sir,
can i use SMD resistors for AX-11
you can
Hello willy can you mail me PCB layout (silk screen,artwork,green masking layouts) for AX-11 to Shravanth.reddy@yahoo.com
coper side is for toner transfer,thanks for warning willy!
Thanks for correct pcb files.
Hello willy can you mail me PCB layout (silk screen,artwork,green masking layouts) for AX-11 to Shravanth.reddy@yahoo.com
Hi Shravant,
See attached maybe this a bit better than the previous file.
Regards,
Attachments
it´s ok - thanks Willy for warning about mistake
Cheers buddy....
Regards,
- Home
- Amplifiers
- Solid State
- 100W Ultimate Fidelity Amplifier