One half of Aleph p 1.7?

[miep]

Hey Folks,

My first post in this forum. excuse me english. I'm not used to write...
So the actual question is:

I want to use the Aleph P as a Bride of Zen with CCS. But where to go with the Bridge at the Sources of the gain-devices?
I build a normal Aleph P and it was just delicious to hear with a F4. To build a "whole" Aleph P and waste one half by short-cutting the output to ground, is uneconomical in my opinion. I didn't found a solution in the web, if there is one, i would be happy to read about it...
A schematic of the plan is attached(which is not working!)
Best regards

Miep

 

[Rodeodave]

So you're looking for an unbalanced, single ended Aleph preamp? Sounds like a job for Aleph L!

I just hope that I correctly understood your question...

 

[miep]

Yes!!

Thank you Dave!!

 

[miep]

I am still curious, if there is a way to get the circuit above working...has anyone an idea

 

[Zen Mod]

if you adopt that circuit from post #1 , as one half per channel , in the end you'll have Bride of Zen

lower CCS is surplus in that case ....... you need source resistor , to define gain etc.

go figure