Hi, I am building the bamtm and the inductor for the tweeter is a .3 mh with .2 ohms acording to his parts list. I purchased the inductor from Madisound and then noticed it is labeled .3 ohms. I can not find a .2 ohm inductor. Can I use this inductor? If not what are my options. Thanks
I am in the process of building this speaker as a starter project. Can anyone answer this question?
What gauge wire was used to wind your .3mH/.3ohm inductor? If it was 20GA, you probably need an 18GA or a 16GA, if it's 18GA, you need 16GA. If you call Madisound, they will help you out with the right inductor. I've done business with them since I was in high school, and they are very helpful.
Dave
Dave
- Status
- Not open for further replies.