Sweet!! Mouser pretty proud of them at ~$5-6 a pop!!!
Ummmm.....just checked you have to order a 1000+ !!!!
Last edited:
Ok stupid question of the day...
I have removed and tested the outputs and identified the one that was bad.
Do I need to pull the power supply semis and check them toi?
I have removed and tested the outputs and identified the one that was bad.
Do I need to pull the power supply semis and check them toi?
OK, I have the bad outputs replaced but I have a new problem...
Apparently I am not smart enough to figure out how to install the clips for the transistors.
Is there a simple method that I haven't figured out?
Apparently I am not smart enough to figure out how to install the clips for the transistors.
Is there a simple method that I haven't figured out?
Well I got everything back in place and installed the 10 amp fuse as recommended but when setting the bias the same two fets blew. At this point I am bowing out and turning it over to a peofessional.
Thanks to everyone's help especially Perry. I have no doubt if I had more time to devote to it I could have fixed it with everyone's help but this is one of those times where I actually have more money than time
Thanks to everyone's help especially Perry. I have no doubt if I had more time to devote to it I could have fixed it with everyone's help but this is one of those times where I actually have more money than time
- Status
- Not open for further replies.