Ok guys, Just shootin' in the dark here, but I have tried to find a service manual for a Musical Fidelity X10 V3 with no luck. Short story, I applied 21v to the circuit, and it didn't like it. So I says, maybe I should get a better picture of things before I go further(never stopped me before). I have been busy upgrading this circuit(just parts change out). Anyway, Looks like I have an open in both channels. Plus, I am getting 29vdc at the heater filament. Is that right? More to come I'm sure...thanks in advance.
Is it an X10 or the X10D
See the thread on this forum titled
musical fidelity x10d schematic (do a search)
It has schematics including one I hand traced from an X10D unit. Some notes on upgrades as well.
Cheers,
Ian
See the thread on this forum titled
musical fidelity x10d schematic (do a search)
It has schematics including one I hand traced from an X10D unit. Some notes on upgrades as well.
Cheers,
Ian
X10 V3
Yes, correct, it is the version three in a square enclosure. I did see a schematic , but no values or voltage readings available with it. Funny how something so popular needs such effort for info. I suspect something is open, and it would be easier to trace with some 'hints'. A signal generator may be a start to see how far down the rabbit hole it goes.
Yes, correct, it is the version three in a square enclosure. I did see a schematic , but no values or voltage readings available with it. Funny how something so popular needs such effort for info. I suspect something is open, and it would be easier to trace with some 'hints'. A signal generator may be a start to see how far down the rabbit hole it goes.
- Status
- Not open for further replies.