• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

WTB: portable, diy prebuilt low impedance amp

Jump to Latest
R

RetroR

Member
Joined 2016
#1
Greetings,


I was looking for someone to build a CMoy modified to be suitable for low impedance and low sensitivity headphones or another DIY amp that would be suitable. No other requirements (though I'd prefer it use regular batteries like AA or other cells, 9volt would be okay).


Thank you for looking and specifically, these would be for a 7th Generation iPod Classic & Audeze Sine headphones. Headphone specs are below:


Specifications
Style


On-ear, closed-back


Transducer type


Planar Magnetic


Magnetic structure


Fluxor™ magnet array


Phase management


Fazor


Magnet type


Neodymium N50


Diaphragm type


Ultra-thin Uniforce™


Transducer size


80x70 mm


Maximum power handling


1W RMS


Maximum SPL


>130dB


Frequency response


10Hz - 50kHz


THD


<0.2% @ 100dB


Impedance


18 ohms


Sensitivity


97 dB/1mW (at Drum Reference Point)


Minimum power requirement


>100mW


Weight


320g
 
You must log in or register to reply here.
Top Bottom