WinISD pro signal and cone excursion question
Hello, could someone please explain - what is WinISD signal in regards to cone excursion?
When I simulate Signal on cone excursion window, and that reaches its maximum - Is the signal rated as RMS, Program or Peak? If its RMS then I should not worry about over excursion, but is its peak then I would have to divide this by 2 to get a program rating and another 2 to get to RMS rating for calculating limiter settings.
for example
RMS, Program or Peak?
Hello, could someone please explain - what is WinISD signal in regards to cone excursion?
When I simulate Signal on cone excursion window, and that reaches its maximum - Is the signal rated as RMS, Program or Peak? If its RMS then I should not worry about over excursion, but is its peak then I would have to divide this by 2 to get a program rating and another 2 to get to RMS rating for calculating limiter settings.
for example
RMS, Program or Peak?
Last edited:
Xmax by default is peak one way yes and it can be changed to p-p
So if this is sine RMS, then by doubling the power (program power) and at point reaching peak power, this should work?
I this case 1000AES (rated AES power for speaker)
2000 Program
4000 Peak
Im only thinking about over excursion now.
So if this is sine RMS, then by doubling the power (program power) and at point reaching peak power, this should work?
I this case 1000AES (rated AES power for speaker)
2000 Program
4000 Peak
Im only thinking about over excursion now.
If at 1200 RMS it reaches Xmax then at 4000 peak the driver will be on the floor? Or Im getting something wrong?
Last edited: