Does it have to be metal ?
Maybe something like these which illuminate too if needed,
--|PB6149L-4|SWITCH, TACT, ILL.RING, BLUE MOM | CPC
Maybe something like these which illuminate too if needed,
--|PB6149L-4|SWITCH, TACT, ILL.RING, BLUE MOM | CPC
being made of metal is not the most important requirement, mainly they have to look nice. those do look nice, thanks.
Hi,
have them made for You. 😉
Just ask a workshop to cut and turn them for You off of a piece of steel or aluminum rod. A slightly rounded top for smart looks and either a flat bottom to glue the knob onto the lever of a tactile switch, or a axial hole drilled into the bottom to fix the knob on the axis of a pot.
See KB-AL30R at VT4C menue "Knobs". You could have something similar with smaller diameter beeing made from a massive Aluminum rod.
Or source a knob from HiFi DIY Site - VT4C/211 Power Triode
jauu
Calvin
have them made for You. 😉
Just ask a workshop to cut and turn them for You off of a piece of steel or aluminum rod. A slightly rounded top for smart looks and either a flat bottom to glue the knob onto the lever of a tactile switch, or a axial hole drilled into the bottom to fix the knob on the axis of a pot.
See KB-AL30R at VT4C menue "Knobs". You could have something similar with smaller diameter beeing made from a massive Aluminum rod.
Or source a knob from HiFi DIY Site - VT4C/211 Power Triode
jauu
Calvin
having some made on a lathe is an option. but those LED lit ones are very nice too. maybe I'll try a combination.
- Status
- Not open for further replies.