Hello,
These are the terminals of the Monacor SP-308CX coaxial woofer. What kind of connector could I use on them?
These are the terminals of the Monacor SP-308CX coaxial woofer. What kind of connector could I use on them?
Last edited:
Looks as if you push down and push a bare wire through the hole.
Looks expensive.
Hole will limit gauge of wire you can use.
Looks expensive.
Hole will limit gauge of wire you can use.
No. don't crimp ferrules. They hold better with bare wire. Use thick flexible wire say 2.5 to 4mm2
No connector but I like to solder just the tip of stranded wire so it doesn’t fray. Also a bit of a blob at the end of the wire stops it from being able to pull out.
By the way, as it's a coaxial speaker demanding an external crossover, where is the second pair of terminals supposed to be located? I don't see it in the global picture.
I don't have the transducer yet so I can't check. However the specifications report that a filter is required, so I guess there's no filter included.
