Hi, I'm going to make a pair of speakers to use along with the Zen V4 I am making, and would like to know what would be a good choice. I have about $150 to spend, and the less the better 🙂. I was maybe 2-ways, and I'd like to make them fairly small, preferably not more than a foot tall. Suggestions for driver combos or plans would be greatly appreciated.
2 way
a 2 way with 5" or 6" Peerless or Vifa mid-bass drivers would probably be a good choice
Pete McK
a 2 way with 5" or 6" Peerless or Vifa mid-bass drivers would probably be a good choice
Pete McK
Tang Band W3-871S, choose whichever enclosure you prefer. You'll find alot of these being used in sealed enclosures, but Bass Reflex really works well with them as well, and of course, an open baffle would always be an option.
full-rangers are another good candidate. my RS 40-1197 speakers (made by dave (planet10) because i wasn't set up yet for making my own) could be made within your budget, assuming you can get your hands on the drivers. Radio Shack is selling out their stock of drivers, so they might be hard to come by now. but if they have 'em, they're a steal at about 4-5 bucks apiece on clearance.
/andrew
/andrew
ron
Yep the tang band in a ML TQWT will give the most bang for the buck or if you can fine them a RS1354a 5 1/4" driver in a TQWT.
ron
Yep the tang band in a ML TQWT will give the most bang for the buck or if you can fine them a RS1354a 5 1/4" driver in a TQWT.
ron
Actually thats just bags of poly fill behind the speakers.The speakers are wrapped in 2 layers of felt and the TQWT has an aperiodic port at the bottom which is covered by felt so it gives the speaker a smooth 1 piece look(no apparent vent).I find the aperiodic easier to tune and gives an almost flat impedance curve.
ron
ron
- Status
- Not open for further replies.