Hello,
I keep meening to finish up my Perl Phono build, and have been looking for a logo to engrave on to the front panel.
I can find the "Pass" logo, but havent seen anything specific to the Phono Preamp.
Is there no specific "Perl" logo, or am i just not seeing the wood for the trees?
Thanks, julian
I keep meening to finish up my Perl Phono build, and have been looking for a logo to engrave on to the front panel.
I can find the "Pass" logo, but havent seen anything specific to the Phono Preamp.
Is there no specific "Perl" logo, or am i just not seeing the wood for the trees?
Thanks, julian
The Pearl is a DIY Pass project.
If you ask Nelson, you may be granted a PassDIY sticker for it. Those stickers are kinda neat.
Magura 🙂
If you ask Nelson, you may be granted a PassDIY sticker for it. Those stickers are kinda neat.
Magura 🙂
Thank you, but...
Im going to end up using a cnc router to cut the front panel anyhow, so i may as well engrave somthing nice whilst im at it - and, plus, i like engraving more than stickers.
Maybee i can just digitise the sticker? I suspect my friend probably pocketed the stickers when he ordered the boards though! : )
(we ordered two sets, one set each)
julian
Im going to end up using a cnc router to cut the front panel anyhow, so i may as well engrave somthing nice whilst im at it - and, plus, i like engraving more than stickers.
Maybee i can just digitise the sticker? I suspect my friend probably pocketed the stickers when he ordered the boards though! : )
(we ordered two sets, one set each)
julian
I'm going to have a Mother-of-Pearl 2 inlaid in a wooden face plate for my Pearl 2 build when the boards are ready, with a PASSDIY sticker on back, of course!
: )
...i actually program a bit of the camel stuff too. Not that i can sepll though. ; )
julian
An externally hosted image should be here but it was not working when we last tested it.
ps. this is the pass diy sticker, right?
- Status
- Not open for further replies.