I own a pair of thiel cs3.7 speakers. I like like them very much. I would like to build a pass disign to drive them. I wonder what disign would be the best to drive the thiels with a minimum load of 2.8 ohm.
What would you reccoment to build?
What would you reccoment to build?
Low impedances are not really the Aleph's forte. Unless
you are listening at low levels, I would consider a push-
pull follower design.
Reminds me that I should do one....
😎
you are listening at low levels, I would consider a push-
pull follower design.
Reminds me that I should do one....
😎
Hmm. probebly the most reliable reply to my topic. Very happy with your responce. But... 😕 This means you don't have a adress for the pcb's already. So this leaves me with the question, build another speaker because i like the aleph 2 and xa60.5 sound (no offence. these are the only ones i heard) or do some research for schemetic / pcb's to drive my beloved thiels.
Please remind me if you did one....🙂
so i can have best of both worlds
Please remind me if you did one....🙂
so i can have best of both worlds
- Status
- Not open for further replies.