Hi all and happy new year,
i'm a newbie and i'd like to understand what happens if i match vb with vas having a qts of 0.31 in a vented box?
the reason i'm asking is to match fb to fs and f3
And if i make a box too big can i correct the port vent to tune the box to avoid boomy bass'?
Scan-Speak 21W8555-10
FS 20 Hz
QTS 0.31
VAS 134 L
SD 220 cm²
XMAX ± 6.5 mm
Electrical Q QES 0.33
Mechanical Q QMS 4.50
Total Q factor QTS 0.31
Suspension equivalent air volume VAS 134 litres
DC resistance RE 5.5 Ω
thanks in advance for any suggestion
i'm a newbie and i'd like to understand what happens if i match vb with vas having a qts of 0.31 in a vented box?
the reason i'm asking is to match fb to fs and f3
And if i make a box too big can i correct the port vent to tune the box to avoid boomy bass'?
Scan-Speak 21W8555-10
FS 20 Hz
QTS 0.31
VAS 134 L
SD 220 cm²
XMAX ± 6.5 mm
Electrical Q QES 0.33
Mechanical Q QMS 4.50
Total Q factor QTS 0.31
Suspension equivalent air volume VAS 134 litres
DC resistance RE 5.5 Ω
thanks in advance for any suggestion
Last edited:
Hi
Happy New Year to you as well. I think best is if you go by the Datasheet of the loudspeaker.
You can find it here, https://www.scan-speak.dk/datasheet/pdf/21w-8555-10.pdf
And to answer your question about the Boomy Bass, and or the vent I find this for you.
vent tuning.
Hope all this helps..
Regards
Chris
Happy New Year to you as well. I think best is if you go by the Datasheet of the loudspeaker.
You can find it here, https://www.scan-speak.dk/datasheet/pdf/21w-8555-10.pdf
And to answer your question about the Boomy Bass, and or the vent I find this for you.
vent tuning.
Hope all this helps..
Regards
Chris