Hi everyone,
I've just bought an Nview Viewframe TFT and it came without a cable. The company logo appears on the screen when the unit is switched on so I think it works but none of the standard cables I've tried have worked with it.
Does anyone know how I could buy/make a cable which would allow to use the panel. I've seen a few mentions of other Nview models but I'm not sure if the interface is the same. (mine has 2 9 pin ports and one standard monitor port. From what I've been able to tell the monitor port is an output for mirroring the panel). I've tried standard 9-25 pin converters and they haven't been any help.
Any info would be greatly appreciated as nview seem to have completely dissappeared.
Best Regards,
Baggy
I've just bought an Nview Viewframe TFT and it came without a cable. The company logo appears on the screen when the unit is switched on so I think it works but none of the standard cables I've tried have worked with it.
Does anyone know how I could buy/make a cable which would allow to use the panel. I've seen a few mentions of other Nview models but I'm not sure if the interface is the same. (mine has 2 9 pin ports and one standard monitor port. From what I've been able to tell the monitor port is an output for mirroring the panel). I've tried standard 9-25 pin converters and they haven't been any help.
Any info would be greatly appreciated as nview seem to have completely dissappeared.
Best Regards,
Baggy
OMG! An nView owner in distress! How did i miss this one! Well, picking up a macintosh to vga adaptor should solve your problem, and do not worry about the 9 pin digital input... it is the analog that is vga 😀.
This link should help you
Good Luck!
This link should help you
Good Luck!
Hey, those are my pictures... I wonder how they ended up there? The original thread is here, anyways: http://diyaudio.com/forums/showthread.php?s=&threadid=16906
- Status
- Not open for further replies.