velodyne dls-r series amp

[toothpuller]

I recently purchased a velodyne dls-r series amp pulled from a dls400r sub. The problem is the amp has hook-ups for an accelerometer and IR sensor. The question is, will leaving the sensor and accelerometer result in a non-funtioning amp, blue smoke, blown driver,etc. If anyone has experience with this amp please post. thanks.

 

[cowanrg]

leaving an infrared sensor unplugged wont do anything.

i didnt think (actually, i KNOW) that the DLS series does not use servo feedback. maybe the connections are for something else? the accelerometer/comparator circuits arent implimented until the SPL or higher series.

but, since there is no servo stuff on the amp, it probably wouldnt hurt to just hook it up.

 

[toothpuller]

velodyne dls-r amp

thank cowenrg, i just didnt want to blow-up my winter project

 

[pinkmouse]

Test it with a dummy load or old speaker that you don't mind destroying before you try expensive drivers.