USBStreamer and 192kHz SPDIF sync???

[HpW]

I have a USBStreamer from the new batch Oct-2014 (with a new eeprom) and have issues to get 192Khz SPDIF sync working. Using my own opto cable it works until 176.4 kHz and with the given opto cable (ends looks like a shower head with plenty of stray lights at the ends) and 96kHz will even not sync.

Does some else have same issue and got a better ToshLink receiver as mentioned JensH http://www.diyaudio.com/forums/minidsp/214068-usbstreamer-multichannel-usb-audio-interface-4.html#post3504588 #31 😕

Any reply on this regard is welcome... even from miniDSP...

Hp

 

[Davey]

Are you testing this with a loopback connection, or some other scheme?

Dave.

 

[HpW]

Are you testing this with a loopback connection, or some other scheme?

I did the test in a loopback connection and also feeding the USBStreamer input from a RME HDSP card, where the loopback on the RME works perfect at 192kHz.

How your USBStreamer works?

Hp

 

[Davey]

Mine seems to work okay with a 192khz loopback. However, it's pretty finicky because if I manipulate the connectors a little bit it loses connection. 🙂

I only have a couple of cheaper plastic cables so don't have more expensive ones to try.

Dave.

 

[HpW]

Mine seems to work okay with a 192khz loopback. However, it's pretty finicky because if I manipulate the connectors a little bit it loses connection. 🙂

Do you use the given with the USBStreamer? If it's the case how the optical ends look like?

The best endings have a very clear cut. You may do the same do scrape with a sharp scalpel. If you connect one to and optical output and have the second opened, you should see a very clear light (not like from a shower brush 🙄).

Some do a tweak using a liquid for better optical flow 😀

Hp

 

[Davey]

I have one of the little tape dispensers used for minor prepping of fiber cable ends.
The cables shipped with the USBstreamer don't look too bad. I have a couple of other cheap cables but they don't work any better (or worse.)

Why don't you swap out the transmitter/receiver blocks as Jen has done?
His streamer interface seems like an excellent addition too.

I don't use mine that much and I only have 96khz (maximum) content, so this project will go near the bottom of my to-do list.

Dave.

 

[HpW]

Why don't you swap out the transmitter/receiver blocks as Jen has done?

The replacement parts has been provided by miniDSP... and I am still waiting to get any feedback from the support...

While it culprit could also be the receiver PLL circuit ...

Hp