Roger that! I've some PSU caps on the way, and a bit of a master plan of how I'm going to make my mini latfet version... It won't be pretty, but it will be distinctive!
Needtubes, I always thought that SuSy meant that the feedback resistors go from the positive output phase, to the sources of the JFET's on the negative phase???
This is a very good project, then my question comes. If I use 2sk170BL/2sj74BL with IDSS about 10 mA, how should the value of the relevant component be adjusted? Because I can't find the matching 2sk170GR/2sj74GR, I hope to get your answer, thank you! ! !
You could just increase the values of R9-12 on my schematic in post 2 to 82.5-ohms. That will give you ~10mA through Q5-8.
- Status
- Not open for further replies.