in the original UcD, the feedback is a voltage signal post the filter. Is it possible to feedback something else? for example, what about the current going throught the inductor? or the capacitor? or the speaker/loan? it can be done via a small sensing resistor, or a little coil around the inductor.
feeding back a current has the added advantage of acting as an overcurrent protection. but I don't know if it would have any practical implication on sound quality.
has anyone done that?
feeding back a current has the added advantage of acting as an overcurrent protection. but I don't know if it would have any practical implication on sound quality.
has anyone done that?
http://www.diyaudio.com/forums/showthread.php?postid=595425#post595425
http://www.diyaudio.com/forums/showthread.php?postid=595425#post595425
The picture is from IVX but I dont found the link.
http://www.diyaudio.com/forums/showthread.php?postid=595425#post595425
The picture is from IVX but I dont found the link.
Attachments
Sorry IVX don’t understand what you mean...
just can´t found the link of your post.
Am I doing some thing wrong?...🙁
just can´t found the link of your post.
Am I doing some thing wrong?...🙁
- Status
- Not open for further replies.