Tweeter / Crossover Advice

[colmo]

Hi jReave
Thanks again, I did not realise that there was more to it than just tweaking the screen shot.
I will go back to 1.2 ohms for R2 and 9.1 uF for C4 i.e your original work.
After building sometime in the future if I have to change anything to meet my ears I may ask for advice then if thats ok with you.

 

[jReave]

Oh yea, certainly that's fine. But don't be afraid to try some small changes to R2 or C4 too if you want. And it's probably easier to start with just a straight 1ohm resistor too for R2.