turn your audio amplifier into power generator (manual)

Jump to Latest
#24
OK, I removed the donation section 😛. And also added some alternative schematics of working devices. I am poor cause I am a fool in Poland they say 😉. I think only schizophrenic like me could achieve working devices like this not being instructed. But once I managed to do, I can share with you my friends 🙂! now it's open sourced... feel free to try audio lovers 😀. PS. Build and find a moron to buy it 😀.
 

Attachments

#27
I will tell you how in few sentences. Take a Robotron RS2500 or RS2510. if you have good skill in electronics i'll try to teach how to make 3-phase system of an amplifier. sadly only few of amplifiers are good for these because of mounting. there is another trick called 'grabber' that you wound around the existing transformer with insulated cable. but i think 1000 turns are needed to this and old type of transformer. i didn't try with cake transformer (toroidal). then you make step up with transformer. this is phase 'G'. Phase 'B' you get as in standard and Phase F is step up after the coil on right channel (needs to be triggered with 50hz not 1khz, but use a 2.5v overload and tune the resistors in right channel). you still use voltage doubler to hold the ps. so you need at all 3 step up transformers 🙂. and the R S T i equal to G F B. though the phase are not superb in degrees, this needs tu be tuned a bit. i don't know how to measure phase degrees, maybe with a scope... this gives only a 1-1,5 kwatt of power, but 3 phases 😀, so you can run a motor that runs an 3 phase 10kwatt AC generator (qmogen) and have household powered. give it a try 🙂 stereo is enough. the only problem for grabber is how transformer is mounted. But Robotron RS2500 is OK. I've managed to build such 30 years ago for an amateur of strange inventions 😉.

Yours sincerely Dxer.

Ps. you may use even two thick coils to have even more current.
ps.2. 3rd channel is rather used to play captret signal for alu covers of capacitors. You play it loop from mp3. 8hz noisy beeps are the best. like the one used to set brain into alpha state. here you use 4,6,8 and 12Hz only, https://mynoise.net/NoiseMachines/binauralBrainwaveGenerator.php record and play loop at maximum volume. again correct resistors in third channel to get more voltage on output. use a soundcard without hum noise cancelling (some laptops use this, try on ATX). Then you connect the signal to most of the big caps around (easier for older units).
 
#28
Here is how I tuned the third phase. I don't know why I was giving there Schottky, but this was somehow more powerful and easier to tune.
paulos_gfb.png
 

Attachments

  • paulos_gfb.png
    paulos_gfb.png
    4.9 KB · Views: 65
#34
Soo, how much money did you earn in the meantime with your ‘free energy generator’?
Spamming this forum with garbage to attract any follower to that failed ‘overunity’ forum makes me 🤢

BTW, unlimited source of free energy exists but it is not that pathetic contraption.
 
You must log in or register to reply here.
Top Bottom