Chris, can't help you as I'm running V5. but if you can't get the library to work then there is a .ulp somewhere that you can use to produce round pad arrays to ease creating your own part.
Thanks for the responses. I realise re-reading my post that I probably was not very clear. I can get the eagle libraries to work that I get from the cadsoft web site, I am having problems with the printed circuit board socket library files that were kindly posted above by Tubelab.
I may have to try creating my own part, but I am only very new to Eagle and just getting used to the basics. If it is any help to people, I have found these tutorials that were helpful to me Tangent Tutorials
Cheers,
Chris
I may have to try creating my own part, but I am only very new to Eagle and just getting used to the basics. If it is any help to people, I have found these tutorials that were helpful to me Tangent Tutorials
Cheers,
Chris
Thank you Lord Tubelab, the Eagle libraries DipTrace export it to, as they were in their forum dispnibles, I found your library and will help me, if not I'll upload the inconvenient forum DipTrace with the respective reference and name, thanks per share.
Angel Baca
Lima, Peru
Angel Baca
Lima, Peru
- Status
- Not open for further replies.