• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

Tube amp fan?

Status
Not open for further replies.
Hey there

I need to source a fan for my tube amp head unit. I'm running some matched hi-gain tubes on the low side and a set of tubes that go into distortion early (#30) on the high side and I'd like to make them last a little longer by pushing some air past them.

I'm thinking a small unit like a computer fan. My kids have several of them that light up, but they're only 12v and I'm looking for some 110 / 115v stuff. Got any Ideas?
 
Most of the computer fans run on 12 V dc, which drives a solid state drive circuit. The 110 volt fans are usually AC induction motors that run at a fixed (high) speed and are usually quite noisy. If you can't find a quiet one, you can run the 12 volt computer fans off of 9 volts, which can be made with a diode and a cap off of the 6.3 volt filament transformer. This is what I use on my amps. At 9 volts these fans make almost no noise, yet move enough air to prevent meltdown.
 
Hummf! Shoulda thought of that. A friend of mine told me it's not your memory that's going, it's just full and kinda plugged up. I feel so much better knowing that.

I went to your site the other day...man how do you do it all?
C???k? And married too! Sheesh! I have trouble taking out the trash and my wife ditched me cause I left the toilet seat up.

Thanks mucho for the idea, I'll get er done.
 
I have come to the realization that my memory is full. For every new thought, an old one goes away, there are no more gigabytes up there! The solution is to not think too hard.

How do I do it? I don't know any more, that's why I am so far behind, too many projects. I thought I would have more time when the kids left...... NAH!
 
Status
Not open for further replies.