Trimming polygon pours in Eagle, help needed

[SunRa]

Hello,

I am now finishing a DAC board with AK4396 and I have a very specific question. How can I control the shape of the polygon ground plane in the marked areas below?

An externally hosted image should be here but it was not working when we last tested it.

An externally hosted image should be here but it was not working when we last tested it.

 

[pinkmouse]

Draw lines in the Restrict, (or could be Keepout, I've just had a fairly liquid lunch 😉 ), layers, that will stop the flood going where you don't want it to.

 

[SunRa]

Hi,

Thanks for the reply, it is indeed Restrict layer, it's much better now. I was looking for something like this for some time now.. (seems liquid lunches do help memory after-all 🙂 )

If you'd like to take a look at the entire development of the PCB, check here