Hi, I'm wondering if the switch is a spdt on this board and what pins are + - . I want to replace the whimpy little switch with something better. Thanks. It's a tpa3116d2.1
Last edited:
Searching for "tpa3116d2.1" might be able to find what you are asking about but it would save a lot of time if you could provide some links to what you are working with.
A switch like this one. http://m.ebay.com/itm/151675151041
Not sure if I'm sharing the link properly.
Not sure if I'm sharing the link properly.
Hi, I'm working on a DIY boombox project using a class d chip amp http://www.ebay.com/itm/12V-50Wx2-1...Subwoofer-Amplifier-Verst-Board-/151590377692 I would like to replace the board mounted toggle switch with something more substantial, this switch 19mm 12V Blue LED Ring Illuminated on Off Push Button Self Locking Flat | eBay However I'm not sure what poles are what on the board switch. I want to de-solder that switch and solder some wires from the board to my new switch which will be mounted elsewhere. I'm not sure but I think the amp has some sort of stand by mode in the switch to prevent a "pop" at power on. Do you think that that toggle would be a SPDT switch? Could I incorporate my new switch which is a SPST? or do I need a different one? I've been looking through many forums to find the answer but can't seem to come to a conclusion. I hope you can help me. Thank you
There are 5 terminals total the 3 in the middle say NC, NO, C the other two are for the led. On the side of the switch it says 5A/250V AC
12V.
12V.
- Status
- Not open for further replies.