I wanted to share my progress for today. I've been looking around, and must admit that I've been confused! I finally found some reference designs, that i hope are the right fit for my project. This was at least what i found and drew today.
My main concerns are the following:
I follow other peoples drawings etc. and might get less than ideal schematics. Maybe the stuff I have made now is a complete mess, that doesn't work at all. Who knows? Well probably people that actually have a better understanding of the schematics etc.
Is there better ways to do this? I guess i wont know
Last but not least, I wanted to hear if you guys think that I'm almost complete. I still need to draw a 48v to 5v 1a dc output. I hope it wont cause any problems to my design.
Edit:
After reading the TPA3255EVM Users guide on Figure 8. TPA3255EVM Schematic 3, they showed how it could be done. Might be a safter bet to follow this instead.
My main concerns are the following:
I follow other peoples drawings etc. and might get less than ideal schematics. Maybe the stuff I have made now is a complete mess, that doesn't work at all. Who knows? Well probably people that actually have a better understanding of the schematics etc.
Is there better ways to do this? I guess i wont know
Last but not least, I wanted to hear if you guys think that I'm almost complete. I still need to draw a 48v to 5v 1a dc output. I hope it wont cause any problems to my design.
Edit:
After reading the TPA3255EVM Users guide on Figure 8. TPA3255EVM Schematic 3, they showed how it could be done. Might be a safter bet to follow this instead.
Last edited: