Is that simple? If recommended port size is 6" diameter and 6" long, and want or need to put 2 ports, can I simply split that number, installing 2 ports that are 3" diameter? If so, can I keep the tube length? Thanks.
You need to have the same cross sectional area.
So one 6" diameter port could be replaced by two 4.2-4.3", or three 3.4-3.5" ports.
Length stay the same.
So one 6" diameter port could be replaced by two 4.2-4.3", or three 3.4-3.5" ports.
Length stay the same.
Last edited:
or rectangular / triangular / slot ports with same effective CSA - the first two of which can be tucked into enclosure corners.
Hi,
The end corrections for corner ports and slots on a side
are different to plain mounted ports on the inside end.
They are somewhat different, don't know the numbers.
rgds, sreten.
The end corrections for corner ports and slots on a side
are different to plain mounted ports on the inside end.
They are somewhat different, don't know the numbers.
rgds, sreten.
- Status
- Not open for further replies.