I am about to refurbish a TD-125, and will also be making a new plinth. I was thinking of maybe making the plinth to also fit the LB armboard, but have not been able ti find the dim's for this.Also - does anyone know if there are some additional fixings except the usual three screews?
Best I can remember just the screws.. Check on Vinyl Engine - The Home of the Turntable , you need to be a member to access the library but I suspect there is plenty of useful information and probably a template there for making the plinth.
I didn't understand the arm board question, perhaps I'm dense.
I didn't understand the arm board question, perhaps I'm dense.
I have a TD125 and there are only three screws holding the arm board. I installed a Mayware Formula 4 arm and had to make a new arm board of plywood. You really need a table saw and drill press to make sure the new board is perfectly rectangular and the screw holes are perfectly vertical.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Analogue Source
- Thorens TD-125 LB armboard dim's