slowmotion said:Or how about these?
An externally hosted image should be here but it was not working when we last tested it.
found on Michael Christs webpage
Cheers
Looks like the back end of the Delorian in Back To The Future...lol
Tim
This is in Hamilton?
To think I grew up just across the border in Buffalo, never had that much fun.
All I remember of Hamilton is the Lion Safari; perhaps I just don’t know how to find the cool places.
To think I grew up just across the border in Buffalo, never had that much fun.
All I remember of Hamilton is the Lion Safari; perhaps I just don’t know how to find the cool places.
Things that make me drool? Hmmm.... My own stereo makes me drool... My 6000W RMS 😱 monoblocks make me drool.... The fact that each speaker and monoblock gets it's own dryer outlet and 60 amp 
breaker.... lol... The fact that it goes so loud the neighbors furniture moves around 
yet it still sounds so clean and transparent that you could swear the band is doing a gig in my listening room? 😎 Now that makes me drool... My 180" TV makes the drool run a bit faster too... 😀
I know I'm bad for bragging... But someone asked what made me drool so there!
breaker.... lol... The fact that it goes so loud the neighbors furniture moves around yet it still sounds so clean and transparent that you could swear the band is doing a gig in my listening room? 😎 Now that makes me drool... My 180" TV makes the drool run a bit faster too... 😀I know I'm bad for bragging... But someone asked what made me drool so there!
Since I had no luck starting a new thread, I think this will be the next best place to post. I want to build a pair (for now) of speakers that will make me drool. I can spend around USD $2,000 to $2,500 for each driver, with each speaker being 3 or 4 way. Of course it would be nice if I did not have to spend that much so I could build up the rest of the system. In other words, I would have to be convinced that it is defenantly worth it. I am open to using "exotic" driver technologies, but this is not a requirement. What I know is that I will probably build a seperate sealed compartment for each driver, and stack them. Also, I plan on amplifying each driver with a seperate amp chennel (and probably use electronic EQs to split the signal before amplification). Please, your suggestions are most welcome.
Thanks!
Thanks!
The subject is audio hardware, not? Because else...
Check there setup:
http://www.galaxy.be/contr4.htm
I wet my pants just reading it 😉
An externally hosted image should be here but it was not working when we last tested it.
Check there setup:
http://www.galaxy.be/contr4.htm
I wet my pants just reading it 😉
- Status
- Not open for further replies.