FYI, my Theta Data III traport started giving hassles-basically the sled motor would continue running even after the tray was fully loaded.
Problem was that the CD was not being clamped and further
investigation and also advice from a US repair shop showed the problem to be a slipping load belt.
Replaced this and everything is working again.
Also, for the record, the Data III is a modified Pioneer CLD-99, I have the circuit diagram.
Problem was that the CD was not being clamped and further
investigation and also advice from a US repair shop showed the problem to be a slipping load belt.
Replaced this and everything is working again.
Also, for the record, the Data III is a modified Pioneer CLD-99, I have the circuit diagram.
Hi Ryan. Just resurrected a scrapper with a belt too... Now the Data Basic II vs Data III shootout looms.
- Status
- Not open for further replies.