Tect clock output only 1.7v HELP!!

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.

audiokid25

Member
2004-10-01 6:28 pm
Ok I purchased a tent clock XO2 from Guido. I needed a 3.3v output and he instructed me to change r21 to a 470ohm resistor. I measure 3.6 volts at the middle pin of the regulator. And Im only getting a 1.7v clock output. Any ideas here? The 1.7v isnt being seen by the chips so I cant even load a disc.:bawling: Any help would be greatly appreciated.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.