Hello everyone,
Just bought this preamp on ebay as a non-working unit. It powers up, everything lights and works, but when a source is connected to either the AUX ou TUNER inputs, there's no sound. 🙁 The tape inputs, both TAPE 1 and TAPE 2 work fine. I currently don't have the schematics. My guess is that it could be either a bad solder joint or a transistor? Can I test the transistors in the circuit or should I take them all? Sorry for the limited knowledge, any help will be appreciated. Thanks.
Just bought this preamp on ebay as a non-working unit. It powers up, everything lights and works, but when a source is connected to either the AUX ou TUNER inputs, there's no sound. 🙁 The tape inputs, both TAPE 1 and TAPE 2 work fine. I currently don't have the schematics. My guess is that it could be either a bad solder joint or a transistor? Can I test the transistors in the circuit or should I take them all? Sorry for the limited knowledge, any help will be appreciated. Thanks.
Hi,
Check that the tape monitor is not engaged and that a permanent
out-in loop (e.g. for a equaliser) is either bypassed or connected.
🙂/sreten.
Check that the tape monitor is not engaged and that a permanent
out-in loop (e.g. for a equaliser) is either bypassed or connected.
🙂/sreten.
- Status
- Not open for further replies.