Hi all ,
Just got pair of Technics 1210 2 months back.starting to face problems in one set.
The problem when ever i take the pitch between -7 to -8 the platter vobles i am able to hear a tear sound this continues till i switch it off and on it again after some time it starts the platter start moving again.
I have a Speaker system beside my turntable is it beacuse of strong magnetic field my fader is dying or is it some thing else.
I am really tensed since i huge amount invested in this its really starting to pinch.
Just got pair of Technics 1210 2 months back.starting to face problems in one set.
The problem when ever i take the pitch between -7 to -8 the platter vobles i am able to hear a tear sound this continues till i switch it off and on it again after some time it starts the platter start moving again.
I have a Speaker system beside my turntable is it beacuse of strong magnetic field my fader is dying or is it some thing else.
I am really tensed since i huge amount invested in this its really starting to pinch.
I had really erratic problems with my 1510 until I traced it down to dirty control potentiometers and switches. Give those a really good cleaning and see what happens. Lemme know cause I'm curious.
good luck
good luck
Could be that the pitch control slider is dirty . You might need to spray a contact cleaner into it to determine that. Better to use one of of those contact cleaners from CRC that leaves no residue or oily deposit. WD40 is something I would not use.
Spray some contact cleaner and move the slider up a down a few times. Do it a few times to ensure the slider is clean.
Cheers.
Spray some contact cleaner and move the slider up a down a few times. Do it a few times to ensure the slider is clean.
Cheers.
- Status
- Not open for further replies.