Looking at using the TAS5613 in a project, but I want to use as a single BTL channel and close the other one down to save current-
The data sheet (page 19) states Bootstrap UVP shuts down the half bridge and doesnot activate the ^SD pin-
Anyone ever tested this?
I was planning on trying it by leaving off the BS caps and putting bleed resistors to gnd.
TIA
The data sheet (page 19) states Bootstrap UVP shuts down the half bridge and doesnot activate the ^SD pin-
Anyone ever tested this?
I was planning on trying it by leaving off the BS caps and putting bleed resistors to gnd.
TIA