Today i received 2 full range tangbands W3-871S and i am wondering how i can get the best out of them, I mean a DIY enclosure (with or witout aditional high or low drivers in it). I prefer to use the Tangbands alone, without additional drivers..
Anyone made somothing that is very good?
Anyone made somothing that is very good?
Wim,
I built Salas' TB3, but it requires 2 871's per side. The thread is here http://www.diyaudio.com/forums/showthread.php?threadid=57210
The bass is quite surprising for a small box.
You could also build Cyburg's Needles. It only requires one driver. I'm still playing around with this, but the initial results are quite good.
-Ken
I built Salas' TB3, but it requires 2 871's per side. The thread is here http://www.diyaudio.com/forums/showthread.php?threadid=57210
The bass is quite surprising for a small box.
You could also build Cyburg's Needles. It only requires one driver. I'm still playing around with this, but the initial results are quite good.
-Ken
Thanks Ken, no problem to order another 2 drivers if the results are good with your design. I am going to read the thread you offered.
thanks for so far.
thanks for so far.
wim said:
Here are a couple of links to a full range monitor using the W3-871S.
http://www.vikash.info/audio/W3-871S
http://www.zaphaudio.com/archives.html
Good luck,
Gio.
Hi,
I´d personally go with the bipole as well but just in case you get tired of those variations here´s another one:
http://www.creativesound.ca/pdf/ELF1.5DOC.pdf
with either of these filters:
I´d personally go with the bipole as well but just in case you get tired of those variations here´s another one:
http://www.creativesound.ca/pdf/ELF1.5DOC.pdf
with either of these filters:
An externally hosted image should be here but it was not working when we last tested it.
- Status
- Not open for further replies.