Hi,
I have the cheap ebay green noname chinese board with ta2024. Would it be possible to set it up in differential input mono way instead of single ended stereo ? Thanks
I have the cheap ebay green noname chinese board with ta2024. Would it be possible to set it up in differential input mono way instead of single ended stereo ? Thanks
If you dont want to hack the pcb then an external differential receiver should be OK.
Loads of examples on net.
Loads of examples on net.
Thanks a lot for reply.
I would prefer to hack this pcb and I have electronics and reverse engineering knowledge butnot in amplifier domain. I know I could add an ina134 balanced receiver IC but if I coulddo else without adding an input stage that would be better to me.
Can you explain if its possible by moding pcb without adding a balanced receiver ?
Do you mean the positive phase in left input, the négative phase in right input and the bridge load single speaker between two output terminals ? I have sommes fear because I think ta2024 ils already BTL which I do note understand all actual consequences.
I would prefer to hack this pcb and I have electronics and reverse engineering knowledge butnot in amplifier domain. I know I could add an ina134 balanced receiver IC but if I coulddo else without adding an input stage that would be better to me.
Can you explain if its possible by moding pcb without adding a balanced receiver ?
Do you mean the positive phase in left input, the négative phase in right input and the bridge load single speaker between two output terminals ? I have sommes fear because I think ta2024 ils already BTL which I do note understand all actual consequences.
- Status
- Not open for further replies.