Hi,
Today I finally finished the PCB for my TA2020 amp. This my first board soon to be going to a fab house. I was wondering if anyone could take a quick look at it. I've tried to keep the analog and digital parts away from each other as good as I could, so hopfully the board isn't the worst one out there 😱.
Link to pcb and schematic (eagle) - http://dl.dropbox.com/u/1008610/ta2020-amp.zip
Today I finally finished the PCB for my TA2020 amp. This my first board soon to be going to a fab house. I was wondering if anyone could take a quick look at it. I've tried to keep the analog and digital parts away from each other as good as I could, so hopfully the board isn't the worst one out there 😱.
Link to pcb and schematic (eagle) - http://dl.dropbox.com/u/1008610/ta2020-amp.zip
So now I fixed the link. I didn't exactly follow Tripath's layout. To tell the truth my PCB is nothing like the one from tripath 🙄
I've found note about pcb layout in on of tripath's datasheets (There are so many revisions). I will try to adjust my pcb to follow the application guidelines. Still it would be nice if someone could take a quick look.
I also have a couple of questions.
* Is it prefered to regulate in incoming power from a smps?
* How close to the edge do one usually place jacks and pots?
I also have a couple of questions.
* Is it prefered to regulate in incoming power from a smps?
* How close to the edge do one usually place jacks and pots?
- Status
- Not open for further replies.