Hello everybody.
I have built a NC400 system and I was about to use my SNOY STR-DA2400ES as pre amp, but the PRE OUTS goes to 150mV and I need about 2V (Z source = 1kOhm) to feed the NC400.
Althoug the Ncore sounds with the sony as preamp, the sound is not what I was expecting for the amount invested.
So I'd like a suggestion for a good matching preamp as simple to build as possible.
Thank you in advance
I have built a NC400 system and I was about to use my SNOY STR-DA2400ES as pre amp, but the PRE OUTS goes to 150mV and I need about 2V (Z source = 1kOhm) to feed the NC400.
Althoug the Ncore sounds with the sony as preamp, the sound is not what I was expecting for the amount invested.
So I'd like a suggestion for a good matching preamp as simple to build as possible.
Thank you in advance
BA3 - A worthy pre for the amp. I am using a simple linear supply, not regulated.
Burning Amplifier Gain Stage for BA-3 – diyAudio Store
Burning Amplifier Gain Stage for BA-3 – diyAudio Store
Thanks.
What about this one?
Servo regulated OPA2604 low distortion low noise opamp stereo preamplifier kit! | eBay
What about this one?
Servo regulated OPA2604 low distortion low noise opamp stereo preamplifier kit! | eBay
These are very quiet and very popular:
FIRST WATT B1
If you're willing to spend a few hundred for something to last many years, the Schiit Jotunheim is world-class preamp with ultra-low output Z, balanced and SE, ultra-low-noise, and is a great headphone amp:
Schiit Audio, Headphone amps and DACs made in USA.
FIRST WATT B1
If you're willing to spend a few hundred for something to last many years, the Schiit Jotunheim is world-class preamp with ultra-low output Z, balanced and SE, ultra-low-noise, and is a great headphone amp:
Schiit Audio, Headphone amps and DACs made in USA.
Last edited:
- Status
- Not open for further replies.