Subwoofer Output on Behringer Ultragraph Pro FBQ6200

Status
Not open for further replies.
Jump to Latest
D

davidherrick

Member
Joined 2013
#1
I have this EQ. My question is the output say's variable, 30-200Hz? So if I have a Subwoofer 18' and it says 38 to 175 hz will this EQ cut out any other frequency's below 100 hz if I set it at 100 hz or just act like a low pass filter and cut out only frequency's above 100 hz? thanks for any help.
 
#2
It'll definitely act as a low-pass filter, set at the frequency you choose. Check the manual for the slope.
I don't know if the graphic eq will still apply to the subwoofer output or not - you'll need to refer to the manual on that one.
 
#3
At the end of each channel, post EQ is a resistor that sums with the one from the other channel. This combined signal is fed through a basic freq filter and a stage to drive the sub out. It is a tunable low pass filter, but it does come after the graphic section.
 
Status
Not open for further replies.
Top Bottom