I have a little subwoofer controller with 2 dual NE5532 op amps that was built from an ebay kit PCB and works fine. I don't have a schematic but stereo input > stereo to mono resistors > gain stage > crossover filter with adjustment 20-200Hz > volume pot.
The question is that the output comes directly from a B50K pot and would like to add a cap (e.g. 4.7-10uF) after this but should I also add a resistor (e.g 100K) to signal ground?
I could add a buffer or an inverting / normal circuit but prefer to keep it simple as it works. This feeds a parallel LM4780 power amp with Zin 47K.
The question is that the output comes directly from a B50K pot and would like to add a cap (e.g. 4.7-10uF) after this but should I also add a resistor (e.g 100K) to signal ground?
I could add a buffer or an inverting / normal circuit but prefer to keep it simple as it works. This feeds a parallel LM4780 power amp with Zin 47K.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.