Sub with three 15" drivers?

Status
Not open for further replies.
Not unless the passive had absolutely humongous excursion. More likely would be a system using 2x 15in passives and 1x 15in driver.

The amp power will depend on the specific implementation of a design, but if everything is optimised the power required will be the total power of the system, which is the sum of the drive units.
 
Blake,

One of the secrets to a good PR system is to not make the drone cones work too hard. Always make sure the potential of the drones is higher the the active, meaning consider a 1.5 to 1 ratio as a good starting point. I know in the old days there were lots of 1 to 1 ie: an 8" cone and 8" drone but you don't see much of that anymore and for good reasons. If you are considering a dual 15" system, consider using 2 18" passives or even 4 15"

But...by the time you have a dual 15 set up, you are often past the point of needing passives. If you need a little extra, try going ported. Argh, that hurts to say. I'm not a bass reflex kind of guy.
 
Status
Not open for further replies.