I will take one last stab at trying to use the IXYS16N10D2 depletion mode mosfets as a drop-in for the LU1014D devices which were originally provisioned in this SRPP based design. I started to sim with them and find that they are working in simulation but with high THD. My objective is try to re-use the PCB enough for testing them revise them if I ever get it working better to produce 10-20w into 8 ohm with lower THD.
Any design advice, encouragements and suggestions are welcome!
My test jig:
Any design advice, encouragements and suggestions are welcome!
My test jig:
Last edited:
@ocer I have been away for work duties but going to try and test out the project on 12-15V power supply as I do not have a large enough 24V-48v psu on hand at the moment. I am just finalizing some parts and mounting. I will try and post an update later today.
Last edited: