Specs on drivers anyone?

[Keltern]

Does anyone have access to specs on the Dali 606 drivers? 🙂

This is all the info written on the magnetlabel:

Tweeter: D26TG-47-06

06 Ohm - 703

Bass/midrange: TC18BG08-12

12 Ohm - 707

The support isn't answering any time soon it seems..

 

[planet10]

The tweeter number sure looks like Vifa, TC18 is also used by Vifa.

dave

 

[phase_accurate]

The Dali woofers are definitley made by Vifa.

Regards

Charles

 

[Keltern]

Yes, I reckoned they were Vifa.. 🙂

But I can't seem to find anything about them, so can any of you guys try? Tried searching around, but no luck.. So I was hoping you could give it a try! 😉

 

[planet10]

They are likely OEM drivers made specifically for Dali -- only Tymphany & Dali will have the specs.

dave

 

[Saturnus]

Almost all Dali drivers are OEM VIFA drivers, however the D26TG-47-06 tweeter is very similar to the D26TG-35-06 (http://www.tymphany.com/datasheet/printview.php?id=255)

The woofer I'm afraid doesn't have a directly comparable off-the-shelf version.

 

[Keltern]

Typical.. ^^

Is there anyone on this forum that's known for having a connection to Dali? 😉

I don't want to throw these away, cause I'd rather use them in a little DIY speaker.. I have two sets of 606, and one of them are a bit shabby, so I thought I'd make use of the drivers..

But it seems it's hard to get specs on them, so I don't know what to do...

 

[richie00boy]

Measure them then. You should anyway if you are making a decent job of the project even if you have manufacturer parameters.

 

[rabbitz]

The woofer should be close to this but with a higher impedance curve.

http://www.tymphany.com/datasheet/printview.php?id=290

In Oz we get a PAE 18WG08 which is basically a TC / BC driver.

http://www.digitalmegahouse.com/peerless audio speakers.htm

 

[Saturnus]

Is there anyone on this forum that's known for having a connection to Dali? 😉

Well, I do business with Peter Lyngdorf but I'm not sure he's willing to disclose such information. I can ask at the next oppertune moment though.

 

[Keltern]

Measure them then. You should anyway if you are making a decent job of the project even if you have manufacturer parameters.

Well, I don't know how decent it'll be, as I haven't built speakers before.. But I'll try to make the best of it! 🙂

Well, I do business with Peter Lyngdorf but I'm not sure he's willing to disclose such information. I can ask at the next oppertune moment though.

Sounds good! 🙂 I just hope I'll be able to make use of them.. It'd be a shame to throw them away just because someone thinks such info should remain a secret.. They're not in production anymore, so I don't see the big deal! But then again, it could just be me! 😛