Had a nice thread about Volume pots for Pass project, how about knobs, nice knobs that finish off a Pass project in style? I checked Ebay, not that many really. My BA-3 as pre is temporarily making do with some Radio Shack knobs that were on hand...it really needs/deserves something nicer!
What say ye?
Russellc
What say ye?
Russellc
I used some of these on my B1: ConneX Anodized Aluminum Knobs
I think Goldpoint has some nice knobs too.
I think Goldpoint has some nice knobs too.
Parts Conexion has nice stuff, as Larry mentions.
Here's an interesting look, using Gibson-style guitar knobs - I really like it!
Oswalds Mill Audio - Monophonic | OMA Vinyl
Here's an interesting look, using Gibson-style guitar knobs - I really like it!
Oswalds Mill Audio - Monophonic | OMA Vinyl
6L6 those are really cool knobs. I ordered a few from Parts connexion, but one of those Gibson knobs for the volume pot would be excellent!
Russellc
Russellc
https://www.tubesandmore.com/search/node/speed?cats[0]=190
They are push-on, and may require a knurled shaft.
Or glue. 🙂
They are push-on, and may require a knurled shaft.
Or glue. 🙂
Got a kid in the neighborhood with a 3D printer? -- there are brass insets with setscrews which can be fitted in...in fqct retro-knobs were mentioned when 3D printing got going several years ago.
Nice stuff, including dale resistor volume pot. excellent diagrams...could have used these, but no 25K pot. I'm sure 50k would have worked of course.
Russellc
From analog metric I picked up a 25k stepped, 4 in 1 out electronic switch and knobs for very little money. However, knobs were missing and took me 3 emails to get them shipped. I got extension rod too. The rod is slightly to big for the panel sleeve. No big deal but buyer beware. 😉
- Status
- Not open for further replies.