I have a class A 10.0 amp that came in for repair. The powersupply was burnt. I was able to replace the powersupply fets and the 2sa152 transistors and the powered up. The problem I have now is the audio. I only have audio on the left channel. If is switch to bridge position I can get audio out the right side but it’s actually Just the left channel audio. Has anyone had this problem or have a schematic for this amplifier?
Attachments
Yeah I noticed that on bridge/stereo/mono switch and airbass switch. I will change all the switches. Is there a point on the driver boards I can check to see if audio is getting to it?
