Sorry if this topic has already been covered, but I'm still not very good at reading schematics and would like some confirmation before I ruin another t-amp as to whether I have this amp wired correctly. Basically, I would like to know if I have correctly wired the different parts of my amp to my panasonic evj.
Thanks
mitch
Thanks
mitch
Hey Mitch,
If that is the pot seen from the rear, it looks like you have the inputs and outputs reversed.
With the connection tabs at the top and seen from the rear you should have:
Rout|G|G|Lout|Lin|Rin
BTW, do you have the new Sonic board? It is not the same as seen there. Check my post in this forum for new photos.
If that is the pot seen from the rear, it looks like you have the inputs and outputs reversed.
With the connection tabs at the top and seen from the rear you should have:
Rout|G|G|Lout|Lin|Rin
BTW, do you have the new Sonic board? It is not the same as seen there. Check my post in this forum for new photos.
There is a photo midway down the page under the caption Potentiometer.
Just click on the word. This goes in concert with Pano's response.
Just click on the word. This goes in concert with Pano's response.
- Status
- Not open for further replies.