soft parts needed for Orion HCCA sub

[nimda]

first off, hello all!

I got my first MECP (whop-ti-do) in 1996... so I have been around a while but I am brand spanking new to this site. It was recommended by some guy I sold some stuff to.....

anyways...

I am looking for all the soft parts or a assembled rebuild kit for an old Orion HCCA 10" sub.

I have a few tolerances (taken with a tape measure, cause I am at work).

It is a standard 4 leg cast basket that has a top ring dia of 10"

It had a dual 8" spider... Can't remember the names but one the names but the lower one was yellow and the top one was black and had woven in tinsel leads. The spacer between the spiders was about 3/8" thick.

the pole is 3" and it looks to have about a 3/16" gap. With a top plate to bottom plate internal depth of about 2.5"

anyone have any ideas where i can get comparable parts....
I am hoping for a 3", dual 2 ohm flat wound coil and a carbon fiber cone.... otherwise, I am considering using some real soft spiders to help lower the power requirements of the sub....

thanks, please lmk if you have any ideas of who might sell parts....

 

[Perry Babin]

It may be better to post this in one of the loudspeaker forums, especially if you're looking for generic replacement parts.